Parts and accessories

Link your pump with this universal drain kit.

This tank is designed to maintain the water pressure in a residential water pump system when the pump is not in operation.

This 3-wire heat shrink splicing kit helps secure pump wire leads to cable. Self-sealing tubing provides quick, leakproof splicing connects #14, #12 or #10 gauge wires with crimp connectors.

This foot valve allows the pump to hold prime and its PVC construction helps extend valve life. Its filtered-intake design prevents large debris from entering the suction pipe. 3/4" FNTP.

This pressure switch is used to turn the pump on at 30 PSI and turn it off at 50 PSI. It controls the water pressure with its simple mechanism that keeps the pressure below a specified setting.

This well point coupling connects to the pipe sections required to drop the well point at the appropriate level.

This snifter valve charges air in your tank and pump. Easy to install. Fits 1/8" MNPT.

This check valve prevents the backflow of water into the pump. Its lead-free brass construction can safely be used for potable water. Lead-free.

This pressure switch is used to turn the pump on at 30 PSI and turn it off at 50 PSI. It controls the water pressure with its simple mechanism that keeps the pressure below a specified setting. 1/8" FNTP brass fitting.

Get this set of four heat shrink splicing cables for your water system.

This kit will allow you a quick and easy installation of a sump pump discharge hose.

This nipple for T tank pipes is used to connect 2 other fittings.